Settembre 2023
-
Fix sprite shadows being drawn on transparent TROR layers
Mostra dettagli
Also fixes sprite shadows being drawn floating above floor slopes.
-
EVENT_PRE/POSTWEAPONSHOOT: Set ud.return[0]/userdef.return 1 to the number of the current shot we're processing in a burst
-
Make some actors work properly with TROR
-
Fix "return to center" triggering after CON_SAVE is executed
-
Generale
Use buildvfs_exists in OutputFileCounter::opennextfile
-
Account for floor and ceiling slopes in renderAddTsprite
-
Fix tsprite cutoff if the sprite stretches across multiple TROR layers
Mostra dettagli
The sprite is now properly copied for each sector it stretches across.
-
Overhaul TROR handling for hitscan() and clipmove()
Mostra dettagli
- Vertically attached sectors are now added to the clipsectorlist - Entirely remove the previous TROR hack from hitscan() - Instead, hitscan() now also uses clipsectorlist, and detects whether a TROR transition floor or ceiling was hit. If so, any subsequent wall hits in the same sector are skipped. This fixes the following: - Collision and hitscan checks where a sprite stretches vertically across more than 2 TROR layers. - Hitscan shots being unable to clear sloped TROR surfaces. - A potential out-of-bounds array access in hitscan()
-
Add TROR-awareness to sprite clipping in hitscan()
Mostra dettagli
Analogous to the previous commit, it also checks the sprites of the upper and lower TROR bunch of the sector. This handles the case where a sprite is intersecting layers, and fixes hitscan shots not hitting enemies properly in such cases.
-
Add TROR-awareness to sprite clipping in clipmove()
Mostra dettagli
This makes it so that the sprites of the ceiling and floor bunch sectors of the sector being checked are also iterated over. This handles the case where a sprite is intersecting TROR layers, and fixes projectiles not hitting enemies properly in such cases.
-
Make clipupdatesector() TROR-aware with compatibility ENGINE_EDUKE32
Mostra dettagli
When checking if a point (x,y,z) is contained within a sector, then if x,y is contained, but z is not, it also checks all attached TROR layers. This fixes terminx/eduke32#24
-
Generale
Fix build failure and warnings if YAX_ENABLE is undefined
-
Fix build error that originated from commit 003320f1
-
Disable Loguru's unsafe signal handler
Mostra dettagli
With this enabled, a interrupt signal would lead to an infinite loop.
-
Fix mapart tiles not reloading properly on map change in Polymost
Mostra dettagli
This only occurred between two maps that had mapart defined each.
- Risolve
- terminx/eduke32#220
-
Allow decreasing sprite repeat down to size of 1x1 in 3D mode
Mostra dettagli
Note: this was already possible by manually editing the repeat.
-
Don't lock up the editor while testing a map
-
Add new tsprite flag TSPR_FLAGS_NO_GLOW (32, hex: 0x20)
Mostra dettagli
Prevents the game from showing the glowmap defined for the sprite. Applied to sprite shadows in Duke3D.
-
fix wall aligned sprite lwall calculation overflow
-
Completely revert attempted jitter fix from 5977025e
Mostra dettagli
This caused two problems: - The change with AC_FZOFFSET caused BLOODPOOL to jitter in Duke3D - The change with water floors caused various actors to jitter in Fury More trouble than it's worth.
Agosto 2023
-
Fix build after big updates in ae4a71a199773d77445a47e6ea80787969b2fd97
-
Give EVENT_POSTWEAPONSHOOT the return value of A_Shoot.
-
Port EVENT_PREWEAPONSHOOT and EVENT_POSTWEAPONSHOOT from NetDuke32.
Mostra dettagli
* Setting RETURN to non-zero in EVENT_PREWEAPONSHOOT cancels the shot.
-
Generale
Make port metadata like path loading more consistent
-
During the 3DR screen, handle events outside the FPS-limited section
-
Clean up voxflags[] a little bit
-
Fix voxel visibility rolloff in classic mode to match sprites
Mostra dettagli
TODO: Polymost
-
Generale
Added Visual Studio Code configuration file
-
Add warning when `terminate` found outside state or event
-
Add warning when `break` found inside loop (and not inside `switch`)
-
Add terminate
Mostra dettagli
- Coautore
- Jordon Moss
-
Add exit and continue
-
Add prependstate and appendstate
Mostra dettagli
- Coautore
- Evan Ramos
-
Internal cosmetic cleanup
-
Generale
CON/VM: Remove VM_NOEXECUTE as redundant to VM_RETURN
-
Fix regression in 611edc9672272fe651d66734c0448be7695b256d
Mostra dettagli
If you made saves since then, loading them will likely scramble your cfg settings, but you should not lose any progress at least.
-
Generale
Remove TSPR_FLAGS_SLOPE_SPRITE and use only CSTAT_SPRITE_ALIGNMENT_SLOPE
-
Fix logic oversights in 6e6b82d4cc9a0434d1ff7a122ae267c3b0e7b21e
-
Generale
Use a tspr->clipdist bit to specify legacy voxels instead of tspr->cstat 48
-
Factor out tspr->clipdist accesses into local variable tsprflags
-
Factor out rendering tests for whether a sprite is a voxel
-
Ensure some hardcoded switch behavior maintains applicability only to wall sprites, not sloped (floor), consistent with the rest of the code
-
Enumify uses of CSTAT_SPRITE_ALIGNMENT (cosmetic cleanup)
-
Fix assertion in get_floorspr_center with regard to sloped sprites
-
Fix screen border tile in Polymer
-
Generale
Fix up many print statements to use loguru so they actually work
-
Generale
Clean up uses of buildvfs_kfd types
-
Clean up exit screen code
-
Avoid OOBs