Revision r2111
👤 helixhorned
📅 2011-11-11 12:05:44 -0800 (Fri, 11 Nov 2011)
Tweak raising/lowering (groups of) ceilings or floors.
Now, if more than one sectors are affected, always move them by the same
amount. That is, if one of them would be sticking against the other side,
don't move the rest. Another change consists of determining the z delta
first, and only then moving the sprites by that amount. This fixes the
problem where you'd e.g. raise a 'floor door' against the ceiling, and the
effector sprites would be raised one time too much, preventing them from
being lowered the next time.
------------------------------------------------------------------------
Raw Content
------------------------------------------------------------------------
r2112 | helixhorned | 2011-11-11 14:39:56 -0800 (Fri, 11 Nov 2011) | 4 lines
Correct thinko with the ceiling/floor movement code. When moving more than one
sector c/f and moving one of them would go beyond the other side (ceilingz >
floorz), don't move any sector c/f at all. When moving only one sector in that
case, move so that ceilingz == floorz.
------------------------------------------------------------------------
r2111 | helixhorned | 2011-11-11 12:05:44 -0800 (Fri, 11 Nov 2011) | 8 lines
Tweak raising/lowering (groups of) ceilings or floors.
Now, if more than one sectors are affected, always move them by the same
amount. That is, if one of them would be sticking against the other side,
don't move the rest. Another change consists of determining the z delta
first, and only then moving the sprites by that amount. This fixes the
problem where you'd e.g. raise a 'floor door' against the ceiling, and the
effector sprites would be raised one time too much, preventing them from
being lowered the next time.
------------------------------------------------------------------------
Eduke32 Changelog Viewer