Original log file · 20111111-2111.txt
------------------------------------------------------------------------
r2111 | helixhorned | 2011-11-11 12:05:44 -0800 (Fri, 11 Nov 2011) | 8 lines
Tweak raising/lowering (groups of) ceilings or floors.
Now, if more than one sectors are affected, always move them by the same
amount. That is, if one of them would be sticking against the other side,
don't move the rest. Another change consists of determining the z delta
first, and only then moving the sprites by that amount. This fixes the
problem where you'd e.g. raise a 'floor door' against the ceiling, and the
effector sprites would be raised one time too much, preventing them from
being lowered the next time.
------------------------------------------------------------------------
r2110 | helixhorned | 2011-11-11 12:05:29 -0800 (Fri, 11 Nov 2011) | 13 lines
A couple of Mapster changes related to saving.
- new mapster32.cfg and OSD variable 'fixmaponsave_sprites', telling the
editor whether to 'fix' the sprite sectnums on saving and entering 3D
mode. Note that a) sprite sectnums are never fixed when 'script_expertmode'
is enabled, as before, and b) sprites that have out-of-bounds sectnums
are still fixed if a proper sector is found
- if saving and some sprite sectnums have thus been tweaked, inform the
mapper on the status line and print the changes in the OSD
- fix update issue similar to an earlier one: when 'saving as', the astub.c-
based file name is now updated too, so saving with Ctrl-S now saves into
the one save with 'save as' (and not the old one)
- don't attempt to recheck wall pointers from scratch (when saving and running
with -check) if it's a TROR map
------------------------------------------------------------------------
r2109 | helixhorned | 2011-11-10 13:47:42 -0800 (Thu, 10 Nov 2011) | 2 lines
Oops. Revert the *alloc wrapping to catch them being called with bad values.
This was meant for debugging only.
------------------------------------------------------------------------
FixEngine
Tweak raising/lowering (groups of) ceilings or floors.
Now, if more than one sectors are affected, always move them by the same
amount. That is, if one of them would be sticking against the other side,
don't move the rest. Another change consists of determining the z delta
first, and only then moving the sprites by that amount. This fixes the
problem where you'd e.g. raise a 'floor door' against the ceiling, and the
effector sprites would be raised one time too much, preventing them from
being lowered the next time.
FixEngine
A couple of Mapster changes related to saving.
- new mapster32.cfg and OSD variable 'fixmaponsave_sprites', telling the
editor whether to 'fix' the sprite sectnums on saving and entering 3D
mode. Note that a) sprite sectnums are never fixed when 'script_expertmode'
is enabled, as before, and b) sprites that have out-of-bounds sectnums
are still fixed if a proper sector is found
- if saving and some sprite sectnums have thus been tweaked, inform the
mapper on the status line and print the changes in the OSD
- fix update issue similar to an earlier one: when 'saving as', the astub.c-
based file name is now updated too, so saving with Ctrl-S now saves into
the one save with 'save as' (and not the old one)
- don't attempt to recheck wall pointers from scratch (when saving and running
with -check) if it's a TROR map
Fix
Already listed in build
2109Oops. Revert the *alloc wrapping to catch them being called with bad values.
This was meant for debugging only.
